Design -- Our shower head holder is 360 degree adjustable design, with two drop-shaped hooks at the bottom, which can hang bath towels and bath brushes. No need to drill, installation fast. Advantages -- The angle of the shower holder can be adjusted at will, so there is no need to worry about not being able to adjust the angle. The reinforced adhesive adhesive is always sticky and will not fall off even after being soaked in water for along period. Specifications -- The shower bracket is an international standard four-point interface, with an inner diameter of 2.2cm. Suitable for 99% of showers on the market. Material -- The shower holder is made of plastic with good toughness and high strength, corrosion resistant, heat resistant and impact resistant. Installation -- The shower holder is very easy to install. First, wipe the wall of where you need to install it with a towel. After making sure there is no water stains, tear off the backing film, then stick it on the walland press hard for a few minutes to complete the installation.