Easy to install. Health and Safety: It is advisable to install a thermostatic mixing valve in public places to avoid burns to users. Ideal for use in the bathroom, bathroom, kitchen, washing, etc. Working pressure range: 0.03 MPa ~ 1 MPa (0.3 kg ~ 10 kg) Ideal working pressure: 0.1MPa~0.5MPa (1kg~5kg). Cold water temperature: 5~29 Hot water temperature: 30~99 Temperature setting range: 20~60, 35~55, 40~50, 30~60 (temperature customizable) Temperature control accuracy: 2 The thermostatic mixing valve can automatically adjust the cold and hot water inlet ratio to ensure that the set water outlet temperature is constant. No power required. The thermostatic mixing valve is a normally closed cold water structure, and when there is no hot water inlet, the cold water is closed. When the hot water supply temperature is lower than the valve's set temperature, cold water is cut off, and only low-temperature hot water within a safe range is produced. When the hot water temperature is higher than 40 , if the cold water is suddenly interrupted, the hot water will automatically shut off to prevent scalding (after the cold water interruption for 3 seconds). Install A. The inchHinch of the thermostatic mixing valve is connected to the hot water inlet pipe, and the inchCinch is connected to the cold water inlet pipe; B. When installing, try to maintain the inlet pressure of equal cold and hot water. Within the allowable pressure difference range, the thermostatic valve can still work normally, but it is within the e case of a large pressure difference for a long time. During use, the service life of the coil may be reduced; therefore, it is recommended to install a pressure reducing valve on the side with higher pressure (when the pressure difference is greater than 0.1MPa) when used under conditions of large inlet difference of water pressure. C. If the cold and hot water pressures are inconsistent, a one-way check valve should be installed at the end with the smallest inlet pressure, or check valves One-way valves should be installed at both ends to prevent hot and cold water. to escape from each other. Notes: When the pressure difference of the valve is more than 0.02MPa, the DN32-DN100 valve should install a check valve, DN15-DN25 has a built-in check valve and does not need to be installed. Quantity delivered: 1 piece