FLOW WATER HEATER FAUCET WITH ELECTRIC SHOWER While the classic water heater heats a large amount of water, consuming a lot of energy and time, the flow heater does not have a hot water tank and only heats the water that flows through it. So in a short time you have hot water, only when you need it and only in the amount you use at that time. This makes it a cost-effective solution, and at the same time has a longer service life, since there is no water tank and thus the accumulation of stone in the components. As long as you have the faucet unscrewed, you will also have hot water that is used as such, without mixing with cold as is the case with a classic water heater. Of course, the prerequisite for its operation is that the pressure of cold inlet water is not too low. Suitable for individual use in the bathroom, it can be easily and quickly installed. It provides ease of use or maintenance and meets your daily hot water needs. The temperature control of the water at the outlet is proportional and depends on the water flow rate, depending on the selected power. The maximum temperature that can be achieved for the production of hot water is 60 C, and the maximum water flow rate reaches up to 3 liters per minute. Approximate 38-42 C is the standard for showering. SPECIFICATIONS POWER: 3000W Temperature control Low electricity consumption Power Supply: 220-240V 50HZ Length of power cable: 110cm Hose length with ok handset. 135cm Waterproof: IPX4 Water pressure: 0,04-0,5 MPa Material: plastic, metal The kit contains 1x heater 1x shower head 1x shower hose 1x Headphone Mount Mounting Pins 1x tap (water outlet) 1x gasket with strainer 2x thread 1x switch between shower and faucet