Feture:            Voltage:5V    Current: 60MA    Process: Epoxy    Material: high rate solar cell epoxy resin AB glue, PCB or fiberglass backplane    Size:  80*45mm    Package include:    1*Solar panel                       Solar Charger     This is a supper mini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip.            This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging    The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating                       Features:            Solar panel input: 4.4-6V    Max charge current: 500Ma    Interface: 2-pin JST connectors(or PH2.0)    Short circuit protection    Continuous Charge Current Up to 500mA    Battery status indication ( Red : Charging , Green: Charged )    Micro-USB Connector            Package A Include            Solar panel *1  Solar charger *1  cable *3                       Package B Include     All set Package Include (battery not include )    1* Solar Panel    1*1S display    1* Solar charger    1* 1S battery Holder    2* CH2 Connector    3* Cable