Car Brake Bleeding Clutch Fluid Bleeder Kit Vacuum Tool Pump Features: Pneumatic brake fluid bleeder, with 4 master cylinder adapters, 90 to 120 PSI brake fluid bleeder used in conjunction with your air compressor, can quickly assist your brake bleed. The simplicity of the tool allows one person to complete it easily. Use this brake fluid drain to flush and refill the entire brake system by itself. Flush and refill entire brake system, 34 oz Waster Brake Fluid ,Tank 24 oz New Fluid tank that inserts into your master cylinder with provided adapters. Specifications: Air requirement: 90 to 120 PSI/6-12Bar Air inlet: 1/4 -18 NPT Air consumption: 180ltr/min Negative pressure: 60% Refill container head material: copper PU hose size: 2m approx. Oil extraction container capacity: 1L approx. Refill container capacity: 0.75L approx. Master Cylinder Reservoir Adapters : 32 to 41mm 28 to 37mm 24 to 32mm 21 to 30mm The package 1*Brake and Clutch Bleeder 1*Refill Container 4*Plastic Adapters 1*BSP Connector Instructions: 1. Take away the dirty brake fluid from the fuel tank. 2. Put back the new liquid. 3. Start the car and connect the hose between the equipment and the brake cylinder. 4. Loosen the screw, but not completely. Then open the valve and start sucking out the liquid. Please close the valve after screwing. 5. Our tool is suitable for General Motors, you can use the cone nozzle provided in the package to avoid air leakage. 6. Please lift the tool over the brake pump to ensure its normal operation. Note: Due to the difference between different monitors, the picture may not reflect the actual color of the item. We guarantee the style is the same as shown in the picture. Please allow 1-2cm errors due to manual measurement, make sure that you do not mind before you