12V 1-Way Car Alarm System Anti Theft Keyless Entry Security Alert Central Door Lock with 2 Remote Control Item Type: Car Alarm System Material: ABS Color: Black Battery Type: Button Battery (included) Battery Capacity: 120mAh Battery Model: CR2025 Power Supply Voltage: 12 (V) Working Temperature: -25-80 (℃) Alarm Mode: Sound and light prompt Alarm Range: 30-100 meters Type: One-Way Anti-theft device Alarm Loudness: 105DB Alarm Response Time: 1S Applicable Models: 12V car general Features: 1. Button 1: Arm The direction light flashes once, the horn and the horn make a negative beep, close the lock and flameout. The LED flashes slowly, and each press is effective, but the second press does not close the lock. If you press to release within 3 seconds after the system is armed, the horn and horn will beep once, and the vibration sensor will be turned off. Exit when armed again. With ACC, close the lock by fortification. 2. Button 2: Release The direction light flashes twice, the horn and the horn beeps twice, unlock, and the LED flashes slowly. If you press it again, it will only unlock. If there is ACC, press the release button to unlock. 3. Button 3: (Anti-robbing) (programmable) Please refer to the function setting table 8 a. Anti-grabbing at the side door: Turn on the ACC, if you open and then close the main driving door, the LED flashes and the lights flash twice, indicating that the function is activated. If the sound is set, the horn will beep twice. To enable the anti-robbing function, you must connect the anti-robbing line to the side door . b. Remote control anti-robbing: Turn on the ACC, press the meter key or mute button for 3 seconds, the light flashes twice, the horn and the negative horn beeps twice, and the LED flashes quickly, indicating that the function is on. If the sound is on, the horn beeps twice and the function is programmable. (See function setting table 8) c. Ignition prevention: If this function is turned on, every time you turn on ACC, the system will automatically activate the anti-robbing function. There is no need to open the door. Press the remote control. After activation, the LED will flash and the car lights will flash twice. If the sound is turned on, the horn will beep twice and the function can be set. (See programming table 10) d. On-site anti-robbing: This function is used when the car is driven out, use an additional remote control (except the 2 remote controls) to emergency stop the car, activate within 60 seconds, the LED flashes, the car lights flash 2 times, if the sound is turned on, the horn will sound 2 Second, the function can be set (see the function setting table), so the optional remote control will stop the car 60 seconds after leaving the car. e. Enter anti-robbing The system enters anti-robbing mode, and the car lights flash twice. If function 13 is also activated, the horn will beep twice, and the LED will start to flash slowly. After 30 seconds, the car lights flash and the horn shouts. After 15 seconds, if function 14 is turned on When the sound is turned on, the current cut-off device (relay) will immediately turn on and send a bad working signal to the engine. After 15 seconds, the current cut-off device will activate again, shut off the engine, lock the door, and the horn will keep beeping. f. Exit anti-robbing: Turn off the anti-robbing system before the horn keeps beeping, or press the emergency contact button once within 60 seconds of the anti-robbing trigger, and then release it. After the horn starts to sound, or 60 seconds after the anti-robbing is triggered, turn on the ACC, press the emergency contact and the security code the same number of times (the factory default is 1 time), and then wait 3 seconds to confirm whether it is correct. 4. Button 4: Tail box, a. Long press the trunk or search for 3 seconds to open the trunk. b. Press the button * and the tail box button at the same time, you will activate channel 3, (see the function setting of channel 3) 5. Deter Press button 1 and button 2 at the same time for 3 seconds to activate the deterrent function. The direction light and the horn flash in negative synchronization, the horn is long beeping, and the flame is turned off for a long time, and the LED flashes slowly. You can only exit by pressing release. 6. Mute fortification Press button * once, then button 1 once, the system will mute the defense, the direction light flashes once, the lock is turned off, and there is no sound. 7. Mute and disarm Press button 3 once, then button 2 once, you will disarm in the mute state, the direction light will flash twice, unlock, and there will be no sound. 8. For automatic defense (programmable), please refer to the function setting table 1. After the engine is turned off and all doors are closed for 30 seconds, the lights flash once, the horn beeps once, and the LED flashes slowly. If the electric door closing system is set, the doors will automatically close. If the automatic defense is in the