Working Voltage: AC/DC 12V-36V AC and DC are both supported. Wide working voltage range covers 12V, 14V, 16V, 18V, 24V, 28V, 36V Working Current: 48ma Quiescent current: 16ma Max Load: 10A Relay, recommended load is less than 5A (60W) Color: white Material: ABS Function: Receiver Manual Button Control & Wire External Button (without transmitter) Wire the Normally Open Limit to the External Button Pin (U--S--D--GND) to realize motor forward, reverse and cycle operation Original state is OFF. In case of power failure and subsequent power recovery, the state remains OFF, and manual activation is required Output State: Momentary, Toggle, Latched can be adjusted via the jumper on the receiver Default shipment setting is Latched. Adjust the jumper on the receiver to switch to Momentary mode. Do not use Toggle mode Momentary mode: Jumper connects to "1&2" Latched mode: Jumper connects to "3&4" Momentary mode operation: Press the "Up" button, the motor runs forward; release the button, the motor stops Press the "Down" button, the motor runs in reverse; release the button, the motor stops Latched mode operation: Press the "Up" button, the motor runs forward; press the "Stop" button, the motor stops Press the "Down" button, the motor runs in reverse; press the "Stop" button, the motor stops If limit switch wiring is not required, connect the UP, Down and COM ports with a wire. This connection is pre-configured before shipment, and you can use it directly when needed When the receiver output state is set to "Latched", a 0.5s time delay is set for forward and reverse switching as a protection function Package Contents: 1 x Wireless Remote Controller (2 CR2016 button batteries not included) 1 x Receiving Controller