160 ultra-bright LEDs, 1-100% brightness 160 LEDs are built inside this cabinet light, while most cabinet lights on the market have them less than 50. The brightness is sufficient for daily use and allows you to use it. With 160 LEDs, one motion sensor closet light is enough, so you don't need to buy and install more. Easy to install and to use The closet lights have magnetic adhesive strips and built-in magnets in the backlights. For iron products or magnetic surfaces, such as refrigerators, iron doors, etc., you just need to install the cabinet lights magnetically. For non-ferrous metal surfaces, just stick the adhesive tape, then install the lamp on the tape magnetically. Suitable for many purposes, very suitable for the kitchen. Closet Lights Turn on the lights automatically when you come home at night. When you open the door, the motion sensor of the closet light will automatically turn on. Compared with ordinary lights, there is no waste. The service life battery life can be up to 2-3 months. The cabinet lights are fully charged. The battery can last 5 hours in 'always on' mode. and 2-3 months in sensor mode. You don't need to charge the closet light motion sensor frequently. You can also use it as a moving light to get into the attic or dark space, or even use the nightlight under the closet during a power outage. 1. USB Charging: The light is red when charging, and the light is green when fully charged. 2. The description of S2 click/double-click operation function is as follows: More and more S2 starts in constant light mode for the second time- S2 twice in a row (green light shows 2 times) is to press S2 twice continuously (blue light shows 2 times) to switch to induction mode all day, then press S2 twice in a row (twice) One-click S2 induction lighting time loop 3 cycle induction time to switch the S2 induction time with one click 20 seconds (the ;yellow indicator flashes 2 times) Click S2, the detection time is 40 seconds (the yellow indicator flashes 4 times), click S2, the detection time is 60 seconds (the indicator yellow flashes 6 times) 3. Click S1, and other working functions are described as follows: If in constant light or induction mode, Press S1 to change the color once, Three colors of light are switched in more order and cycle-cold light-warm light-all lamp beads are on at the same time S1 , start pressing and hold to gradually fade to bright.getveryrich