12V 2‑Pin Toggle Switch (Rated 3A) Key benefits Reliable on/off control for low-current 12V systems: simple toggle operation for lights, small motors, fans and other electronics. Durable construction: polycarbonate (PC) shell resists impact, corrosion and wear for longer service life. Ready to install and use: internal circuit pre-wired for consistent conductivity and two color-coded wires for fast, unambiguous connections. Tool-free mounting option: self-adhesive back lets you mount the switch without drilling or hardware. Specifications Type: 2‑pin toggle switch Rated voltage: 12V Rated/maximum current: 3A (maximum operating current 3A) Maximum recommended voltage: use at voltages lower than 24V Housing material: PC (polycarbonate) Wiring: two approximately 75 cm (each) pre-wired leads, red (positive) and black (negative) Mounting: mini form factor with self-adhesive backing What makes it practical Color-coded wires (red/black) reduce wiring mistakes and speed up installation. Pre-wired internal circuit improves electrical contact and reduces installation time. Compact size and adhesive mounting allow placement on dashboards, control panels or tight spaces where drilling is undesirable. Typical applications Vehicle accessories: switch roof/fog lights, interior LEDs or small 12V accessories in cars, motorcycles, RVs and boats (ensure load ≤ 3A). DIY electronics and hobby projects: simple on/off control for 12V hobby circuits, small motors, or testing setups. Small appliances and systems: control low-current pumps, fans or lighting strips that operate at 12V and under the 3A limit. Installation notes (simple and safe) Confirm your device operates at 12V (or under 24V) and that the load does not exceed 3A. Clean and dry the mounting surface, peel the adhesive backing and press the switch firmly in place. Connect the red lead to the positive input and the black lead to the negative/ground. Test operation before finalizing wire routing. Keep within the specified electrical limits for safe, reliable performance.