Description: 1.This epoxy resin is mainly used for the outermost layer of the wires loop. 2.This epoxy resin glue is a special curing glue for making raft fishing rod tip, card holder, and fishing rod guide ring DIY. 3.Especially suitable for fishing friends to make DIY rods (raft rods, lure rods, etc.), simple to use and convenient for DIY. After curing, the surface is smooth and the inside is firm. 4.It is recommended to test a small amount for the first time to accumulate experience. Apply a small amount of glue first, penetrate into the guide ring first, and then increase the amount according to the actual situation. 5.The cured product has high bonding strength, good toughness, impacts resistance and vibration resistance. How to Use: The surface of the object to be bonded should be kept dry and clean. It is not advisable to mix too much glue at one time. Mix the two components A and B according to the ratio requirements, and mix them well before use. It is recommended that the mixed glue be controlled at 30 Used up within -40 minutes, it can be positioned within 50-60 minutes after gluing. It reaches about 50% of the highest strength in 3 hours, and reaches the highest strength after 24 hours. Notice: After the A and B are mixed, they must be mixed evenly to avoid affecting the curing. Keep the seal after opening the B component. The more glue mixed together, the faster the gel time. Pay attention to ventilation in the working environment, and avoid contact between materials and skin during use. Features: Material: Epoxy resin ,curing agent Color:Transparent (as shown in the picture) Size: as shown in the picture Package Includes: 2 x Fishing Rod Glue Note: 1.Due to the different monitor and light effect, the actual color of the item might be slightly different from the color which is showed on the pictures. 2.Please forgive 1cm/0.39in-3cm/1.18in measuring deviation due to manual measurement. Thanks for your understanding