4-PIN RGB Extension Wire Cable Cord Connector For 5050/5630 RGB LED Strip Light Product Feature： Durable: High quality PVC plastic wire cover and tin plated copper core ensure steady, safety and long-lasting connection. Quick Connector: Connect strip to wire without stripping insulation, no soldering, no need to peel off waterproof cover, quick and flexible connection. Extension: Compatible with 5v, 12v, 24v led strips, support up to 5A current carrying, allow you to connect longer LED strips by one connector. Convenient: DIY led strip to wire connection length you want, no mater strip-to-wire extension or strip-to-strip jumper, free from the limit of terminal position. Applicable: Work for IP65 PU surface waterproof (not Silicone surface) 10mm/0.4in width 5050 5630 RGB 4 pin strip light 30~120 LEDs/Meter, suit for 22-20 AWG solid wire/strand wire. Product Specification： Type：Strip to Wire Connectors and 16.4ft 22 Gauge 4 Pins Conductor Extension Cable Material：PVC plastic Quantity：10pcs strip to wire connectors + 5m/16.4ft 22-gauge 4 pins conductor extension cable Suitable for：Make sure your LED light strip is 10mm/0.4in width 4 pin waterproof RGB strip light. Not work for non-waterproof or 8mm/0.32in width led strip lights Package Included： 10 x Strip to Wire Connectors 1 x 16.4ft 22 Gauge 4 Pins Conductor Extension Cable How To Use： Strip End 1.Ensure your LED light strip is waterproof 10mm/0.4in width and has 4 contacts (+, B, R, G). 2.Open the transparent cover of connector up to 90 degrees. 3.Peel off the tape around the cutting line area on the back of the LED strip, then insert the LED light strip into clasp side, with the 4 contacts of the LED strip sitting on the 4 pins of the clasp. (Note: No need to peel off the silicone on the surface of led strip around soldering line area) 4.Close the clasp down with force by pliers. Wire End 1.Cut the desired wire length you need and separated the 4 wires (20-22AWG) around connection part. 2. Insert wires into the connector guide slot; make sure that positive & negative on the strip light surface are corresponding to correct wires. 3.Close the transparent cap with a pliers until it is fully seated on both sides of the bottom base. Ensure the metal joint pierces through the wire insulation. (Note: No stripping wires. Positive wire is matched to "+" input power mark on the strip light surface). NOTE: Ensure your Wire Diameter is within range 20AWG-22AWG /0.34~0.75mm² and without stripping wire.