1,DSP + PLL,the frequency is more stable,the frequency will not change with the environment to a frequency . 2,without any adjustment to bring the of DIY beginners. 3,the frequency can be continuously adjusted within a specified range. 4,with a microphone input and speaker volume can be controlled via digital potentiometer. 5,audio input volume can be adjusted via a digital potentiometer. 6, power can be adjusted continuously (non-linear) between the maximum power of 0.5W to 7W. 7, the power output is good harmonic suppression network, the output spectrum cleaner 8, frequency and volume have power failure protection, you do not need to set the ! Now the mitter to make a brief introduction: control panel components: mainly by M8 Series MCU and LCD display and keypad. mitter board components: digital FM mitter chip + 9018 + 2SC3355 + 2SC2851 + 2SC1971 four high frequency power amplification and power conditioning components. Input voltage: 12V DC the input current: approximately 1.0A the audio signal: Maximum input Vpp less than 1V microphone type: cylinder microphone or microphone power output: 0.5W-7W adjustable 6, the output impedance: 50 7, the operating frequency: 76M-108MHz 8, frequency step: 0.1MHz 9, distortion: 0.03% to 0.1% a, board size: mitting plate: 100 x 60mm, Dashboard: 55 x 36mm b, launch distance: more than 5KM (provided that the open area mit antenna height above the surrounding buildings erected height of 10 ) c, stereo separation: more than 63db colour:blue Material:Metal+pc Package Contents: 1 * 7W FM stereo PLL FM mitter 1 * Lcd Screen Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.