5V isolate with MCU, and effectively protect MCU; 5V indicator on board. Voltage indication of motor driver output end; can solder heat sink. Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V supply (can share with MCU 5 V). Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output. Isolated chip 5V supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 55V to 27V. Input voltage: 6V-27V Maximum current: 43A Input level: 33-5V Control : PWM or level Duty cycle: 0-100% Input port: 1RPWM: forward level or PWM signal input, active high 2LPWM: Reverse level or PWM signal input, active high 3R_EN: forward drive enable input, high-level enable, low level off 4L_EN: Reverse drive enable input, high-level enable, low level off 5R_IS: forward drive current alarm output 6L_IS: Reverse drive current alarm output 7VCC: +5 V output, 5V supply connection with the microcontroller 8GND: signal common low end Colour:Photo Color Material: ABS Size: 5 x 5 x 3cm Package Contents: 1 x Motor Driver Module Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.