Feature: 1. ABS Key Film Removal: Equipped with ABS toggle key to remove the film. If there is any jam during laminating, press the ABS key to easily remove the film, so you can operate it safely and stably 2. Keys and Scales: This compact laminating machine adopts touch buttons, convenient to operate; Provide clear scales and markings for easy determination of paper size, saving time on your projects 3. Cold and Hot Laminating: This photo laminator is versatile for both cold and hot lamination, operating with ≤55db low noise for a quieter work environment, making it suitable more laminating tasks 4. Applicable Range: Supports laminating in multiple sizes of A4-3 inch, compatible with thickness of 0.1-0.5mm. This laminator is suitable for photos, menus, documents, certificates, drawings, and more 5. High Efficiency: Using quartz electric heating wire, preheating time does not exceed 2 minutes, laminating speed reaches 355mm/min, has high laminating efficiency, and low energy consumption Specification: Item Type: Laminator Product Model: FN337 Power: 400W Film Removal Method: ABS Toggle Key Laminating Size: A3-3 Inch Heating Method: Quartz Heating Wire Laminating Width: Approx. 330mm / 13in (A3) Laminating Thickness: 0.1-0.5mm Preheating Time: ≤2min Temperature Range: 115℃-145℃ Laminating Speed: 355mm/min Noise Level: ≤55db Size: Approx. 445 x 145 x 88mm / 17.5 x 5.7 x 3.5in. Package List: 1 x Laminator 1 x User Manual Note: Non stick paper, foggy white pieces1. Not complete the preheating, the temperature is not enough, wait for the laminating machine to complete the preheating (green light) and then use2. Thickness gear is not correct, select a higher gear, warm up and then laminateNo working or heating of the laminating machine1. The power supply is not fit, please check the power supply specification before powering on the laminating machine.2. The switch is not set to on hot mode, set the switch to on hot mode.Bubbles, wrinkles, bent photos1. Incorrect thickness gear, select a lower gear, cool down and and then laminate.2. The rollers of the laminator are not flat and there are debris, check the rollers and clean them.3. Laminating objects are not placed on the level, there are debris, laminating before removing debris, put the objects on the level and then laminatied.What should do if there is a paper jam?1. Not correctly feed the paper, the roller on the foreign body, switch off and hold down the ABS key for the film, clean the rollerSmoke over the laminating machine1. Normal vulcanization of the new machine imagined, a normal phenomenon of the new machine, more than a few times will disappear.2. Power supply voltage does not match (burnt flavor), please check the power supply specifications before powering up.