{"version":"2.0.0","moduleList":[{"type":"html","html":{"content":" Technical Parameters Rated voltage: DC 12V, 24V, 36V, 48V, 72V, 96V, 100V, 120V, 200V, 240V etc Rated current: 80A, 100A, 125A Breaking capacity: 6KA/10KA Trip characteristics: B (3-5)In Polar number: 1P (1 Pole), 2P (1 Poles), 1P+1P (Dual power switch with lock function), 2P+2P (Dual power switch with lock function) Current limit level: 3 Quick closing Electrical life: 10,000 times Mechanical life: 20,000 times Operating ambient temperature:-30 C to +70 C Conform to standard: GB10963/ IEC60898 Warraty: 18th MonthCircuit Wiring Recommend1. Please use the protector in combination according to the actual load and circuit, and select an appropriate current Amp.2. When charging the battery, please disconnect the protectors marked No. 2, 3, 4 (or the main switch at the load end of the line) so that the current does not flow to the load end. Can also add a seperate protector on the charger and battery terminals specifically for battery charging protection. 1P, 2P wiring circuit wiring recommendation, the number of circuit breakers can be increased and decreased as needed 1P+1P, 2P+2P wiring recommendation, This circuit breaker can realize the function of switching between two power supplies and has a self-locking structure inside to prevent the danger of two power supplies at the same timeProduct Size (Unit mm) Structure Introduction 1: Terminals (Maximum 35mm2 (3 AWG) cable can be connected).2: Status window, red means power is on, green means power is off (circuit breaker triped).3: Manual opening and closing handle: turn up to turn on the power supply, turn down to turn off the power supply.4: Rail mounting buckle, the circuit breaker can be directly installed on the DIN rail without screwsMounting and Fixed 1, DZ47B125 can be fixed on DIN rail directly, can be placed in a distribution boxPlease try to keep the vertical installation, and use the top-in and bottom-out wiring method, in order to obtain the best protection performance and the longest service life2, Method one: screws fixed, use 3mm or belown screws to fix circuit to wall or distributionpanelNotion1. Even if there is a circuit breaker protection, there is still a certain danger, if the battery temperature is too high, please disconnect the charging power supply in time.2. Please keep the terminal clean, please do not open and close the handle too quickly in a short time to avoid shortening the service life of the product.About