Dent Puller Kit Dent Repair Rods Adjustable Width Auto Body Dent Repair Kit with Golden Lifter Glue Machine for Car Motorcycle Item Type: Paintless Dent Repair Kit Glue Machine Power Frequency: 50Hz 60Hz 100W Material: Metal+ABS Suitable for: Cars, Motorcycles, RVs, Fridges, Washing Machines Instructions: Step 1. Clean the surface of the dent. Step 2. Insert the glue stick into the glue machine and heat it up, connect the power supply and preheat for 5-10 minutes. (This dent repair kit comes with a glue machine and glue sticks. There is a switch on the handle of the glue machine that needs to be turned on and preheated for 5-8 minutes before the glue can be used.) Step 3. Select the appropriate size of glue pulling tab based on the dent size, then apply the heated glue on the tab, immediately place the tab in the center of the dent and hold it until it sticks. Step 4. Let the glue cool for about 5-8 minutes. Cooling time should be less than 10 minutes, slightly shorter in winter. (The glue stick is suitable for temperatures between 0 and 40 degrees. If the temperature is below 0 degrees, the hot melt adhesive may solidify quickly and not stick. In this case, use a hair dryer to heat the joint before using this product.) Step 5. After the glue has cooled, use the golden dent lifter or bridge puller to align with the dent and press down the puller to lift the dent. Repeat the above steps until the dent is removed. Step 6. After the dent repair is completed, use alcohol to clean the body and the left glue on the puller tabs. Note: This dent repair tool kit can effectively repair 90% of dents, but may not achieve 100% repair results. Please read the instructions carefully before purchase.