1. Increase the camera with a moving guide --- When applying a chip, our spare camera can show the orbiting line without extra device, the guide line automatically varies according to the motion direction of the car. You can turn off by cutting the switching cable on the camera 2. High-definition assembly backup camera --- 4089T CCD image sensor-960720 pixels, to support the high-quality night vision image, the 0.01 flux is compatible with the most blind spot body covering most blind spot areas, it will only be adjusted in an old way. By adding the viewing angle seals, you can rotate the rear camera lens section to find the viewing angle with the help of a mini switch, you never need to worry about the too high or too low image shown on the monitor. Mini Design, Solid Shinning Metal Conservation, Shock -Trust, Longer Service Life 4. Cut the green cable to close the guide line with a rearview camera with the 4th Linlemic orbit. Please re -connect the power supply after cutting any cable, and if necessary, you can connect it back after cutting the cable. We have fulfilled the entire camera body with waterproof silicone rubber, tested every camera under water for 24 hours, will work properly under extreme conditions 6. You do not need to use the trigger detection cable for normal mirror monitors or TFT monitors. While working with a radio head unit, please don't forget to connect the trigger wire