The F722 is a 3-8S 36x36mm mini flight controller with a 16MB flash memory, 5V 10V dual BEC. Designed for easy maintenance and low interference The PCB adopts high-end composite material, which has stronger overcurrent capability and good heat dissipation. MOS adopts high current resistance mos, low energy consumption, and strong load capacity Using industrial grade , high temperature resistance. High-quality capacitors, strong filtering performance Intelligent control: The controller has a built-in low-noise button, which can be controlled remotely by one button Maximum power: The OSD allows you to control your drone with maximum speed and accuracy, while providing a smoother flight Model: F722 Flight Controller MCU: STM32F722RET6 IMU: -42688 OSD: AT7456E Baro: SPL06-001 : 16MB Input voltage: 3-8S Lipo(11.4-36V) 5V-BEC: 5V/2.5A 0.1V 10V-BEC: 10V/2A(USER1) IO2: USER2 Receiver: ELRS(CRSF), TBS(CRSF), SBUS.IBUS.DSM2.DSMX UART: UART1/2/3/4/5/6 IIC: 12C1 Led Strip:YES Buzzer: 5V ESCsignal: Support PWM, Oneshot125, Oneshot42. Multishot Dshot150, Dshot300, Dshot600 USB: TYPE-C Current port: YES Voltage sensor:YES DFU DFU button: YES Firmware: for Betaflight 4.3.1 JHEF7DUAL.HEX Mounting Hole: 30.5x30.5x4MM for TEARCKEP BLS-60A 4in1 ESC HV 3-6S Aperture: 30.5 x30.5mm (after installing the ball, the aperture is 3mm) Firmware: BLHELI-S Input voltage: LIPO 3-6S Continuous current: 60A Maximum current: 65A (10 seconds) Processor: EF8BB21 Drive signal support: DShot150-300-600/Multishot/Oneshot/PMW Current sensor: supports Colour:Black Material:PCB Package Contents: 1 x F722 Stack Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.