Durable: these metal hold down brackets are made of metal materials, strong, durable and lightweight, easy to install and less likely to deform or ; They are suitable for most blinds or windows and can you for a long time Appropriate size: It is suitable for most blinds and does not take up too much space; ordering, check the size carefully and make they can match your windows or blinds Simple design: blind hold down brackets are simple in design, small in size, thus, they are difficult to be noticed; Using to hold down most blinds will not affect the overall appearance of the blinds, and you can enjoy the beautiful scenery from the windows as well Easy to apply: the installation and application of these tools are rather easy and convenient; , you put the pins into the holes of the brackets, and then reinforce and you can successfully apply ; For more details, refer to the installation steps Proper simple appearance: These metal hold down brackets are simple in design, small in size, thus, they are difficult to be noticed. Using to hold down most blinds will not affect the overall appearance of the blinds, and you can enjoy the beautiful scenery from the windows as well. Installation procedures: 1. What you need: drill, screwdriver, tape measure, hammer, pencil. 2. If the bottom rail is not fitted with pins, drill a . 1/2 inch deep 7/64 inch or 3/32 inch bit in the center to hold pins on both sides of the rail. 3. Punch the pins in. 4. Put the blind plate down, put the bottom rail flat in place, and the position of the fixed bracket with a pencil. 5. Screw the bracket to the door. 6. Measure the position of the bracket now screwed to the door and on the other side. 7. Then repeat the above steps to installthe second bracket. colour: silver Material: metal Size: About 42x32.2mm Package Contents: 4 x Hold down brackets With screws 4 x Pin Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.