Mini Handheld Spectrum Analyzer 100kHz to 5.3GHz 4in Spectrum Analyzer Signal Generator for Tinysa 5V USB Item Type: Spectrum Analyzer Signal Generator Material: Alloy Steel Battery: Polymer battery x 1 Battery Capacity: 3000mAh (shipped with built in battery) Storage: 32G memory card (included) Screen Size: 4 inches Maximum Low Input Frequency: 800MHz, 6GHz in super mode High Input Range: Unavailable The Resolution Filter Is Divided Into 1,3, And 10 Steps: From 200Hz to 850kHz Maximum Low Output Frequency: Sine wave up to 800MHz, square wave up to 4.4GHz Low Output Level: -104dBm to -16dBm High Output Frequency Range: Unavailable High Output Level: Unavailable Ultra Mode: Calibrated to 6GHz level Internal LNA gain: 20dB up to 4GHz Internal Step Attenuator: 0-31dN Points Displayed Per Scan: Maximum 450 0 to 350mhz Scan Time: 165ms Minimum 0 Span Time: 17ms DANL Low Input at 100MHz: -153 DBM /Hz (LNA off) /-169 DBM /Hz 880MHz DANL High Input: Unavailable DANL Falls In Super Mode: 10dB above -2.5GHz, 25dB above 5.3GHz Phase Noise At 10khz Offset: -92 DBC /Hz Phase Noise At 100khz Offset: -108dBc/Hz Low Input 1db Compression Level: +0.5dBm (low noise amplifier off), 26.5dBm (high noise amplifier on) IIP3 without LNA IIP3 Without LNA: +18dBm (at least 2MHz apart) /0dBm (at 500Hz apart) IIP3 with LNA IIP3 With LNA: -8dBm (at least 2MHz apart) Storage Card Slot: Storage card Firmware Update Mode Activation: Press the touch button before boot AM Modulation Depth: 10% and 100 percent FM Offset: 1kHz to 300kHz Modulation Frequency: 50Hz to 5kHz(AM) or 1kHz(FM)