4 Wave Spray Silicone Hand Soap Cake Mold DIY Aromatic Gypsum Mold Essential Oil Cake Decoration Accessories Bakery Supplies|Cake Molds[name]: silicone hand soap mold[Shape]: wavy flowersDimensions: 17.1 x 14.5 x 3.1cmsingle hole 7 x 5.6 x 2.9cm.[weight]: About 170gMaterial: The new environmentally friendly material is heat-resistant from 240 degrees to minus 60 degrees silicone.Silicone mould's cleaning and maintenance?1. Before using for the first time, clean with clean water or detergent to remove surface dust. Before the mold is used for baking, a small amount of butter can be applied to the inside of the mold. When using the die, if there is an empty tank, water can be added to the empty tank, and no empty burning is allowed.?2. After each use, it can be soaked in diluted detergent for 10-30 minutes. Please use soft cloth to clean. Do not use rough cleaning ball to clean the mold, so as to avoid scratch damage. After cleaning, please dry it and put it in the storage box. The silica gel is easy to react with static electricity and will absorb the tiny particles and dust in the air. When it is not used for a long time, it is not allowed to be directly exposed to the air.?3. When using the oven, be sure to place in the middle of the oven, and the heating tube to maintain a distance of about 10cm, and the oven four walls to maintain a distance of 5cm, so as not to damage the mold at high temperature.?4. part of the mold has a crack this is the factory has been cut, is convenient for buyers to demould. If no incision, can not be demoulded. When in use, wrap a plastic film or rubber band around the incision and pour into the liquidFeatures of silicone mould products:?1. The main component of silicone Silicone is silicone, a natural component found in sand, stone and crystals. It's not rubber Ruber, it's not plastic Plastic Silicone is a rock on the beach, low carbon environmental protection.2. Silicone has a high softness, corrosion resistance, temperature, suitable for cooking, baking, and simple and practical.?3. Through detection, it is sanitary, healthy and convenient to clean, which can prevent the breeding of bacteria and fungi. Therefore, there are a large number of silicone products in infant products and medical products. For example: nipple, silicone plastic, etc.?4. Recyclable, durable and low energy consumption.5. Has a stable structural and aesthetic performance, and therefore has high and low temperature resistance, temperature resistance range. Temperature-resistant minimum temperature of minus 40 degrees, maximum temperature of 230 degrees, heat-freezing uniform.6. It has corrosion resistance to cleaning agents and other kinds of corrosive substances and is easy to clean.?7. After use, no raw materials will stick to the mold.