Automatically charges the battery. The controller features an integrated rectifier and brake circuit module, offering improved heat dissipation and reliability compared to traditional designs. Features a fully sealed, waterproof design with a protection rating of IP67, allowing for long-term operation even when submerged in water. Note: Ensure the wind turbine generator's output voltage matches the battery's rated voltage. Connect wires in the following order: first connect the battery's positive and negative terminals to the controller, then connect the wind turbine's three-phase output. Follow the instructions carefully when connecting the battery and wind turbine to the controller. Reversed polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the battery's positive and negative terminals to the corresponding positive (red) and negative (black) battery terminals on the controller. 2. Connect the wind turbine's three-phase output to the three-phase input (green wires) on the controller. Specifications: - Maximum input AC voltage: AC35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ±0.3V / 29V ±0.3V - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ±0.3V / 29V ±0.3V - Protection level: IP67 - Static power consumption: 0.008A - Maximum load power: 800W - Maximum allowable wind speed: 12 m/s - Operating temperature range: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Compatible with 12V/24V systems - Installation: Bolted - Avoid reversing positive and negative terminals to prevent damage Application: Wind charge controller Color: Blue Material: Aluminum alloy Package Contents: 1 x MPPT Wind Generator Controller Note: The package includes only the items listed above. Other accessories are not included. Due to lighting effects and monitor settings, the actual color of the item may vary slightly from images. Measurement error allowed within ±1-3cm.