The PM02 is an to provide your and Pix32 with clean power from a LiPo battery as well as current draw and battery voltage measurement via a 6-position cable Onboard switching regulator outputs 5.2V at 3A for up to 10S LiPo batteries The power module comes fully assembled with XT60 connectors and wrapped in shrink tubing for protection The power module is designed to power , Pix32, RC receivers and accessories (GPS, radio). It is not designed for servo power GH terminals are also compatible with for Pixhawk4 and for Pixhawk4 mini Maximum input voltage: 60V Maximum current sense: 120A Configured for 5V ADC for voltage and current measurements BEC regulated output 5.2V and 3A maximum 6-position Molex cable plugs directly into /Pix32's 'PM' connector 6-position GH cable plugs directly into Pixhawk4/Pixhawk4 mini 'PM' connector (Due to different batches, the printed words on the product be different, which does not affect use) Colour:As Shown Material:plastic Package Contents: 1 Module 1 x Molex 6-position cable 1 x GH 6-position cable 1 x English manual Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.