The Raspberry Pi Pico is a microcontroller board based on the Raspberry Pi RP2040 microcontroller chip. It has been designed to be a low-cost, high-performance microcontroller board with flexible digital interfaces. The Raspberry Pi Pico features two ARM Cortex-M0 cores run up to 133MHz; 256KB RAM; 30 GPIO pins; and a broad range of interfacing options. This is paired with 2MB of onboard QSPI Flash memory compatible with code and data storage. In addition to powerful hardware resources, Pico has rich and complete software support and community resources. It comes with a complete Rasberry Pi official C/C SDK, Micropython SDK. Just click to get started with Raspberry Pi Pico. Pico has been designed to use either soldered 0.1 pin-headers it is one 0.1 pitch wider than a standard 40-pin DIP package or can be used as a surface-mountable 39;module 39;, as the user IO pins are also castellated. There are SMT pads underneath the USB connector and BOOTSEL button, which allow these signals to be accessed if used as a reflow soldered SMT module. Specification: bull; RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom bull; Dual-core Arm Cortex M0 processor, flexible clock running up to 133 MHz bull; 264KB of SRAM, and 2MB of on-board Flash memory bull; Castellated module allows soldering direct to carrier boards bull; USB 1.1 with device and host support bull; Low-power sleep and dormant modes bull; Drag-and-drop programming using mass storage over USB bull; 26 times; multi-function GPIO pins bull; 2 times; SPI, 2 times; I2C, 2 times; UART, 3 times; 12-bit ADC, 16 times; controllable PWM channels bull; Accurate clock and timer on-chip bull; Temperature sensor bull; Accelerated floating-point libraries on-chip bull; 8 times; Programmable I/O PIO state machines compatible with custom peripheral support