RGBW Pool Light Remote 252LED Colorful Underwater Landscape Lighting IP68 Waterproof 18W AC12V Item Type: Underwater Light Material: PC+ABS+Resin Weight: Approx. 1188g / 41.9oz Diameter: Approx. 26.2cm / 10.3inHeight: Approx. 4.3cm / 1.7inCable Length: Approx. 180cm / 70.9inCraft: The inside of the lamp body is used with fully enclosed resin, which is water-proof Battery for Remote Control: 1 x 23A 12V Alkaline Battery (Not included) Power: 18W Color: RGBW Lamp Beads: 2835 SMD Light Chip Number of Lamp Beads: 252LED Luminious Flux: 2500LM Beam Angle: 120 Degrees Diffused Lighting LED Life: 50000h Waterproof Rating: IP68 Installation Notes: 1. Drill 5 holes (four screw holes and one wire hole) on the wall of the swimming pool. Use 4 long screws and 4 expansion screw tubes to install the fixing bracket on the wall of the swimming pool. 2. Pass the 180CM power cord through the wire hole on the wall to facilitate subsequent connection to the power supply 3. Use short screws to fix the lamp on the bracket through the screw holes on the surface of the product (the area around the fixing bracket must be flat and flush with the surface of the fixing bracket, which ensures the distance between the lamp and the wall no clearance fit. 4. Disconnect the total current, ensure that the surface is installed in place, connect the power cord to the AC12V transformer output line, and connect the other end of the transformer to the output power supply 5. Install a 23A 12V alkaline battery in the remote control (not included) 6. Turn on the power, turn on the lights, and complete the installation 7. Pull out the receiving antenna of the remote control to control the light switch, color and mode.