Cooling Fan Kit Superior Performance DIY Complete Tools S600 Water Pump 10 Tubes Heat Dissipation CPU Cooler Kit for PC Item Type: Cooling Fan Kit Material: ABS,Brass,Aluminum Alloy,Acrylic Main Accessories: 10 Pipes Integrated Water Drain Assembly with Fan: Interface: Straight Mouth Fan Size: Approx. 12cm / 4.7in Fan Interface: Big 4pin Water Drain Specification: Approx. 120mm / 4.7in Drain Size: Approx. 152mm / 6.0in Approx. 60mm / 2.4in Approx. 120mm / 4.7in GPU Water Block Assembly (with A Pack of Mounting Screws): Material: Brass,Aluminum Alloy Contact Copper Surfaces Size: Approx. 50mm / 2.0in A Pack of SC600 Water Pump Components,Pagoda Screws: Power: 10W Head: 3 Meters Stream Rate: 500 Liters / Hour 140mm Cylindrical Water Tank Components: Water Tank Material: Acrylic,ABS Water Tank Diameter:Approx. 50mm / 2.0in Water Tank Height: Approx. 140mm / 5.5in With A Pair of Black Water Tank Brackets,A Pair of Silver Brackets,A Pack of Mounting Screws Hose (Transparent) Assembly (A Pack of Accessory Copper Mounting Screws): Hose Material: TPE Hose Length: Approx. 2m / 78.7in Hose Size: Inner Diameter: Approx. 8mm / 0.3in Outer Diameter: Approx. 10mm / 0.4in Water Cooled Liquid Filling Device25. Show that the water block is installed 26. Install the graphics card back to the computer motherboard and fix the effect picture 27. Fix the cooling fan to the cooling water drain (note: the fan is sent to the radiators) 28. The effect diagram of fixing the heat sink on the chassis 29. The display diagram of the follow-up connection between the pump and the water tank. In the actual situation, you can change the follow-up method, and go back and install it at will. 30. Fix the water tank rack in the proper position of the chassis, and then snap the water tank into the buckle 31. All accessories are fixed, measure the length of the pipe at each position of the pipeline, and then cut the pipe 32. Put the tube skull on both ends of the tube 33. Casing Skeleton Method 34. Connect the weft waterway like this, and then put the pipe skeleton on the joint with pliers 35. Then check whether each waterway is installed properly to avoid water leakage 37. Connect the power supply of the water pump to the position of the previous CPU fan, and the big 4pin interface of the fan can be found on the power supply to insert it.