Standard 2 Relay Output Function DIN Rail Thermostat with Sensor NO NC COMMON -40~110°C DIN Thermostat with sensor, High/Low Temperature 2 Alarm Relay NO NC COMMON Output 7A/250VAC, AC90~260V Features: - Strong anti-interference ability, stable performance, simple circuit and high precision; the outer shell adopts a DIN rail casing, which is easy to install and has a sleek appearance. - Includes adjustment and digital filtering functions. - Standard 2 relay output function, contact capacity 7A/250VAC. Specifications: - Power supply: AC90~260V, power consumption less than 2W (other voltages available on request) - Measuring accuracy: 0.5% FS - Measuring range: -40~110°C - Display: 0.36 inch high brightness red LED (other colors available on request) - Operating environment: -10~60°C (relative humidity below 80%) - Dimensions: 110 x 36 x 60 mm - Sensor cable length: 1.5m Package included: - 1 x DIN Rail Thermostat - 1 x Temperature Sensor Code Table: - TY1: Relay 1 output alarm type 0: Upper limit alarm – when temperature ≥ AL1, relay closes; when temperature ≤ (AL1 - HY1), relay opens. 1: Lower limit alarm – when temperature ≤ AL1, relay closes; when temperature ≥ (AL1 + HY1), relay opens. 2: Upper and lower limit alarm – relay closes when temperature ≥ AL1 and opens when temperature ≤ (AL1 - HY1). - AL1: Relay 1 set point: -40.0~130.0°C - HY1: Relay 1 hysteresis: 0.1~130.0°C - TY2: Relay 2 output alarm type 0: Upper limit alarm – when temperature ≥ AL2, relay closes; when temperature ≤ (AL2 - HY2), relay opens. 1: Lower limit alarm – when temperature ≤ AL2, relay closes; when temperature ≥ (AL2 + HY2), relay opens. 2: Upper and lower limit alarm – relay closes when temperature ≥ AL2 and opens when temperature ≤ (AL2 - HY2). - AL2: Relay 2 set point: -40.0~130.0°C - HY2: Relay 2 hysteresis: 0.1~130.0°C - SEC: Relay action delay time: 0–999 seconds When AL1 or AL2 conditions are met, the relay activates after SEC seconds delay. Delay is disabled when set to 0. - LC: Temperature calibration offset: -20.0~20.0°C Displayed value = Measured value + LC