Specification:100% brand new.Working voltage: For DC 12V (9V~14V)Static Current: <=4mAWorking temperature: -10~+50Remote control working voltage:DC6V/9V/12VRemote control frequency range: 315Mhz or 433MhzRemote control distance: open areas150MItem Size: like the picture show.Package Size: about 15.8cm(L) X 9cm(W) X 6.5cm(H)Features:- 100% Brand new.- Phonic alarm, it can be use to locate your motorcycle- Engine immobilization and anti-hijacking functionality- Four sensitivity alarm settings- This is a simple DIY installation unit with no special tools neededFunction Key: (4 buttons)Arm/Anti-robbery: Remote lockDisarm: Remote unlock styleRemote Start Engine: Remote start styleFind Vehicle: A bell styleFunctions:1. Arm: Pre the Arm/Anti-robbery button, the indicator light flashes once, the siren beep once and the status of alarm will be activated automatically after 3 seconds.2. Disarm: Pre the Disarm button, the indicator light flashes 2 times and the siren beep 2 times, then the alarm system is in the "Disarm" mode.3. Remote Start ON: Within 2 seconds, the connection pre the start button twice, to start the engine.4. Remote Start OFF: In the start state, Pre the Disarm button to stop the engine.5. Find Vehicle: Pre Vehicle Finder button, the indicator light flashes 15 seconds and siren beep 15 seconds, Allow owners to find the location of the vehicle, to stop pre any button.6. Anti-robbery and Aistance: When the motocycle is bobbed and is drive away, the motorcycle owner only pre the Arm/Anti-robbery button, the engine will stop at once, the siren will beep and the indicator light will flash.7. Shock Sensor:Warn away: After arming if any light impact, the indicator light flashes 5 times and siren beep 5 times.Full Trigger: After arming if any heavy impact, the indicator light flashes 1 seconds and siren beep (6 tones) 15 seconds.8. Ignition Trigger: The ignition trigger: in the alarm state, if anyone tries to ignition, the siren starts alarming and the indicators starts flashing.9. Immobilizer: in the alarm state, the siren starts alarming, the indicator light flashes and the engine cannot be started.10. Shock Sensor Setting: Keep preing the fine vehicle button, the remote can adjust the sensor sensitivity of level 1 to 5, according the number of siren beep to set level, (level 1 lowest, level 2 low, ... , level 5 highest)Note:for remote start engine typePackage Included:1x Motorcycle alarm host machine2x remote controls1x storage InstructionNote: The remote control does not contain batteries for logistics reasons.